Description
One flat print opens almost every lid in the kitchen. Slide the lid into the V-jaw until it wedges, then turn. The jaws carry asymmetric ratchet teeth arranged point-symmetrically, so both jaws bite when you turn counter-clockwise (seen from the engraved face) – the loosening direction. Flip the tool over and it tightens. An engraved scale shows where 30–80 mm lids seat. Good for weak grip and arthritis (accessibility angle). Hang it by the hole.
Dimensions
230 × 116 × 11 mm · jaw arms 15 mm · teeth 3.2 mm pitch × 1.3 mm deep · fits 256 mm beds (diagonal on 220 mm beds)
Print settings
FDM: print flat as modelled, no supports. PETG recommended (tougher teeth), 0.2 mm layers, 5 walls (teeth and jaw arms are load paths), 30 % gyroid. Not for food contact – it touches lids, not food.
Resin: too long for small resin plates; standard resin is too brittle for this load. FDM only.
AI-assisted design: this model was created with AI-assisted parametric CAD (build123d), then checked for watertight, printable geometry. Not yet test-printed; feedback welcome.
This model is licensed under
Creative Commons Attribution-NonCommercial
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Wedge-Grip Jar & Bottle Opener – 22 to 88 mm Lids, Flip to Tighten Entered in Tools & Functional Prints
Print Profiles
+Show Print ProfilesDiscussed in
Similar models
camping • camp kitchen • hook
Clip-On Edge Hook for Camp Tables and Chuck Boxes (Parametric)
HomeKitchenChallenge • bag holder • bag stand
BagBloom — One-Piece Bag-Opening Stand, 110 × 110 × 118 mm
caliper holder • digital caliper • skadis
Comments