Description
Steam Deck stand with an open bay underneath for the official docking station. The bay is 136 x 80 x 34 mm and the dock is 117 x 50.5 x 29 mm, so there's room to spare. Two side towers hold the Deck above it.
It's three parts, the floor and two side supports. They join from underneath with 4 self tapping screws, #8 x 5/8" into 3.5 mm pilot holes. The heads sit in counterbores so the bottom stays flat. Rubber feet go underneath, and four 1 mm silicone pads on the spots the Deck rests on.
Something to check before relying on it: the dock's built in cable is only about 15 cm long and has to reach up from the bay to the Deck. That reach hasn't been tested yet, so plug it in and look before calling it done. Same goes for the vents, the back buttons and the microSD slot on your Deck.
Meant for the LCD and OLED models without a case. PETG, no supports needed.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
USB-C hub • hub stand • hub holder
Port Ventilated USB-C Hub Stand | Strap-Mount Hub Bridge | Desk Cable Management
cable organizer • SD card holder
Comments