Description
The saddle is curved, 76 mm long and 46 mm wide, so the headband rests on a broad surface instead of a thin hook. The base is a shallow tray for a mouse, a controller or whatever piles up.
Fit
Headbands up to about 42 mm wide. Measure from the top of your headband to the bottom of the ear cups, or the mic if it hangs lower. Under 210 mm should clear the base.
Hardware
- 2x #8 x 5/8" flat head screws, post to base
- 1x M4x40 bolt through the joint, with nut and washers
- saddle pad around 70 x 40 mm and 4 small feet
The cross bolt is not optional. It's what holds the two halves of the post together.
Printing
Base flat. Lower post standing up with a brim. The top piece goes on its side with supports under the shaft. Keep supports out of the tenon and the bolt hole. Two small test pieces are included for checking the joint fit first.
No load testing has been done yet, so give it a gentle shake test with your headset before leaving it there.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Comments