Description
Arch stand for the PS5 DualSense. The two black saddles bolt into slots on top of the arch so they can slide in or out to meet the grips. They start at 96 mm center to center. A 10 mm channel runs through the base if you want a cable going up to the controller.
You'll need 2 M4x20 screws, 2 nuts and 4 washers, plus a pair of thin silicone pads for the saddles and some small rubber feet. A tiny M4 hole test is in the files.
Print the arch in PETG with supports under the top of the arch. The saddles go flat with no support.
This is only a display stand, nothing charges. It's sized for a bare standard DualSense. The Edge, back paddle attachments and cases weren't accounted for. The saddle spacing is a starting point worked out from Sony's overall dimensions, not a scan, so set them against your own controller before tightening.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Discussed in
Similar models
headset stand • headphone stand • gaming headset
Headset Stand with Wide Saddle and Tray
Apple Watch • watch band • band holder
Comments