Description
Simple stand for the original 2023 ROG Ally. Two curved rests sit on a slotted bar. Loosen the screws, slide them to where the grips land, tighten. Around 128 mm apart is a good place to start.
Parts list: 2x M4x16, 2x M4 square nuts (7 mm), 2 washers, four small silicone pads, four feet.
The square nuts go into the channels under the bar. Check that the screw tips don't poke out the bottom.
The rests lie on their sides to print and the bar lies flat. No supports, PETG.
RC71L only. The Ally X and the newer Xbox Ally are shaped differently and weren't considered. Set the spacing with it powered off and keep the back buttons and vents clear. Sizing is from ASUS's listed dimensions and hasn't been tried on real hardware yet.
This model is licensed under
Creative Commons Public Domain
This licence allows derivative works. Open it in a tool to build on it — credit is filled in for you when you publish.
Comments